extend buttstock plate

[RUSH2112]

What would be the best way to get about an inch more at the bottom of the plate? I haven't seen any stocks that appear to extend lower, except for a couple alternative designs which I don't want to go with. I want to add about this much:

http://filebeam.com/2c869171b14b2553957a7df378f13145.jpg

[furioso2112]

For what purpose do you want to add heighth? Upon reading the thread title, I wondered if you were looking for a length of pull adjustment, but it seems from your picture that you are looking for something like a rear pod. Fabricating one might be effective, depending on its intended use (as a rest, for instance). But if you are looking to get higher purchase on your shoulder, the ergonomics might be tough to get right.

[vafish]

I assume you just want to get the gun higher in your shoulder.

I would think the easiest way would be to cut an aluminum plate and bolt it on.

[RUSH2112]

Yeah I'm just trying to get it a bit higher on my shoulder, just an inch or so. I have vertabrae fused together in my neck and it's uncomfortable trying to get low enough for a solid cheek weld.

I'll see if I can make my own plate extention. I already have a spare buttpad I can put on there when I'm done.

To be honest something like lowracer's Hammerhead design would be ideal, but I want to keep the standard m4 look. No reason other than vanity I suppose.

[smokin762]

Maybe this can help you.

http://www.tapco.com/proddesc.aspx?Id=d212aa03-4ccb-4e1c-adae-8272e10b4097

I have always used these before and I like them.

http://www.bravocompanyusa.com/M4-Rubber-Buttpad-p/stock%20buttpad%20for%20m4.htm

[RUSH2112]

This is probably a better pic, the first one can be misleading.

http://filebeam.com/d0528a8944ae3f9f5e3e83e13e94621b.jpg
Looking to add an inch here