Striker wear on Walther P99 [Archive] - Glock Talk


View Full Version : Striker wear on Walther P99

01-30-2010, 08:32
I just picked up a new P99 Compact, and when comparing it to my well-used P99 I see a lot of wear on the striker of the P99. I thought the striker was hardened steel and shouldn't wear. The gun works fine.

Am I looking at:
1. Normal wear that will eventually require striker replacement
2. Abnormal wear that requires striker replacement now
3. Deliberate modification for some unknown reason
4. Nothing - I'm crazy.

The area in question is the bottom left of the striker in these photos - this is where the trigger bar contacts the striker on a DA pull. The dirty one is the P99, the clean one is the P99C

P99 (used with unusual wear):

P99C (newish with unworn striker):

02-05-2010, 05:55
My vote on this one is only to say....When in doubt replace dont want this piece of artwork weapon going south at a bad time