question of magazine release [Archive] - Glock Talk

PDA

View Full Version : question of magazine release


rigjumpr
02-07-2010, 08:22
is there a way to increase the ejection force of the magazine?:dunno:

looking at the schematic, it must be controlled by gravity because i see no spring.:dunno:

is this a "problem" that can be solved or am I pissing in the wind?:faint:

Dolomite
02-07-2010, 08:25
pissing.

No j/k.

the magazine spring ejects the mag

rigjumpr
02-07-2010, 13:03
hummm, not following you.

the mag spring, could you elaborate a little please?

Mark L Miller
02-07-2010, 13:15
the mag spring is pushing up on either the follower or the rounds in the mag up against the bottomof the slide. When you push the mag release, that pressure is relieved by forcing the mag downwards. This is why if the slide is open, the mag may or may not pop out of the gun with as much force as normal. If you have slow to release mags, they may be dragging on something. For example, some of the glock mags will get deformed on the front sometimes right at the top of the mag. The polymer will get pooched out by bullets feeding from the magazine pushing the poly forwards. This will slow down or retard the mag drop. To solve that one, just take a sharp knife & trim off the offending poly. Sometimes that will happen around the mag catch notch.

MLM