G19 Conversion Question

[Timor]

Hello all,

I purchased a Glock 19 3rd Gen (three pin) a few months ago.

I had the grip frame modified by Cold Bore Customs in Katy Tx, who did a magnificent job.

More recently I traded for a 3rd gen Glock 32. It came with a Lone Wolf 9mm conversion barrel. I really like the versatility of two calibers in one gun, however I want the grip mod done to my G19 without dropping another $200.

Can I put the G32 upper on my G19 lower?

Someone on another forum said that all I would have to do is install a G32 ejector since both are three pin models.

Someone else suggested I pose the question here so here I am.

Thanks for any and all assistance.

Tim

[JR]

If your G19 frame is a 3rd gen you can put the 32 upper on it. You will also need to change the trigger housing from a 9mm to a 40/357.
FYI: The trigger housing included the ejector. Glock does not offer the ejector alone. It must be purchased with a trigger housing.

[Timor]

Thanks JR, for the information.

I'll be putting in an order with Lone Wolf as soon as you get more of your G23 barrels in stock.

Tim