ruger 22/45 magazine doesn't drop out [Archive] - Glock Talk

PDA

View Full Version : ruger 22/45 magazine doesn't drop out


cangler
04-17-2010, 00:11
I had bought this ruger 22/45 pistol recently, it was the last one they had... display model... and even at the dealer, I noticed the magazines wouldn't drop freely out when you push the mag release button. In most cases, they will drop just enough for you to be able to pull it out with two fingers... like it comes out about half an inch or so. It really bugs me, but it was the last one they had, and this particular model is hard to find. Anyways, as far as I know, the magazine is suppose to fall out easily on this gun... would a typical gunsmith be able to resolve this issue you imagine? I have no idea why it gets stuck... but hopefully it's fixable. I prefer all my handguns guns to have a drop free magazine release.

zxracer3
04-17-2010, 00:22
The magazine won't drop out because of the mag safety. You need an OEM mark II hammer bushing or an oversized clarck's custom mark II hammer bushing (for less play in the trigger), in order to remove the mag safety. Then once the safety is removed your mags will drop free. There's no other way.

cangler
04-17-2010, 11:55
Ahhh, that makes sense.

So, where do you think I could find either of those hammer bushings, not real clear what they look like either.

Thanks!

cangler
04-17-2010, 11:59
What about doing this instead... http://www.youtube.com/watch?v=gVHCuHnyMfg

zxracer3
04-17-2010, 19:54
Here you go:

1) Clarks custom bushing: http://www.clarkcustomguns.com/22pts.htm

2) OEM bushing: (ruger won't sell them to the general public so Volquartsen makes one) http://www.midwayusa.com/viewproduct/?productnumber=946649&utm_source=froogle&utm_medium=free&utm_campaign=649

cangler
04-17-2010, 21:33
thanks, that was helpful!

Glock2008
04-25-2010, 19:35
If you have a dremel you can also just buy some flat washers at the hardware store and grind a flat spot on one side and use that to replace the mag safty.