do the pass thru dies de-cap?

[mikecurnow]

should have said push thru in the title.

I was wondering if the push thru dies also decap, and if not how do you make use of them in the common progressive press's (LNL, 550, ect)?

Thanks
<input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden"><input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden"><input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden">

[Colorado4Wheel]

They don't decap. They are also better suited to a single stage press. The push through section is designed like the shellholder on a Single Stage.

[dudel]

should have said push thru in the title.

I was wondering if the push thru dies also decap, and if not how do you make use of them in the common progressive press's (LNL, 550, ect)?

Thanks
<INPUT id=gwProxy type=hidden><!--Session data--><INPUT id=jsProxy onclick=jsCall(); type=hidden><INPUT id=gwProxy type=hidden><!--Session data--><INPUT id=jsProxy onclick=jsCall(); type=hidden><INPUT id=gwProxy type=hidden><!--Session data--><INPUT id=jsProxy onclick=jsCall(); type=hidden>

:supergrin: How could they? If there's a decapper pin, something is holding it in the die. How would you push the brass past that?

You also don't use them in a progressive press because that would hold on to the brass. You're not using a standard shell holder with the push through dies. It's more similar to a boolit sizer.