Shooting Technique [Archive] - Glock Talk

PDA

View Full Version : Shooting Technique


Fodshaker
05-30-2010, 19:41
Mas,
Went to the range yesterday and shot terrible. (I think I would of done better throwing the rounds down range) Every thing was low and to the left. I am a right handed shooter, left eye dominate, shooting a Glock 27 w/ Laser Guard , 180 gr. ball ammo. My laser is sited for 20' and I was shooting at aprox. 60'. I suspect something is wrong with my grip? Any suggestions on where to start to solve my problem?
Thanks!

Mas Ayoob
05-31-2010, 07:00
Fodshaker, the hold on the gun can indeed throw shots low left for a righty. Make sure you're using a firm two-hand wraparound grip (not with the left palm forming a "saucer" under the "cup" of the firing hand). The tighter you hold, the less likely you are to "milk" shots low left. Milking occurs when the other fingers sympathetically tighten with the trigger finger. If those other fingers are holding as tight as they can already, they can't tighten anymore sympathetically.

However, the first thing I'd do would be to readjust your laser sight. You mentioned that you set it up for point of aim and point of impact to coincide at 20 feet, and were getting low hits at 60 feet. Because the laser beam emits from below the barrel, when you get farther than 20', the line of the laser has crossed the line of the bore, which will put the laser dot progressively farther above point of impact as distance increases.

This may also account for leftward straying of shots, as a tendency to hit lateral that might go unnoticed at 20' will be more pronounced at three times the distance.

Try re-sighting the Laser Guard to send its beam parallel to the barrel, and make sure that it's centered laterally with the shot group at 60'. With that set-up, you'll always be hitting an inch or two directly above the dot, and will know where the shots will go at any reasonable "combat distance."

Give it a try, and let us know on here how all that works for you.

Best,
Mas

Fodshaker
06-01-2010, 09:00
Mas,
Thank you for the advice. I will give it a try and report back.