New Ameriglo Sights

[Shadetreeman]

Should I use blue or maybe green loctite on the screw of my front sight?

[bentbiker]

Blue works fine. If you use green, you need to be specific as to the number. I think it is #609 that is low viscosity for press fit parts, and #290(?) that is OK.

[Shadetreeman]

Cool Thanks,

[lethal tupperwa]

clean ALL oil off parts.

[samuse]

I clean the slide, sight and screw with Berryman's B-12 carb cleaner and use red Locktite on the head, the threads and all faying surfaces of the sight.

It wouldn't come off even if the screw wasn't there!

[gator378]

Blue works fine. If you use green, you need to be specific as to the number. I think it is #609 that is low viscosity for press fit parts, and #290(?) that is OK.

+1 for Blue

[Genin]

BLUE is what I use

[RayB]

I've used both blue and red, with careful attention to cleaning, as lethal tupperware points out, with complete success.

Make sure any final adjustment is a tightening adjustment.

Let sit at room temp for 24-hours and you're good to go! :thumbsup:

--Ray

[inkballedtarget]

Blue will work fine. Just be sure to degrease and clean well.

Cal