Trouble removing trigger guard [Archive] - Glock Talk

PDA

View Full Version : Trouble removing trigger guard


glock30user
05-26-2011, 15:13
I have a Stag 2TL and am trying to replace the trigger guard. My issue is I canít get the old one out. I have tried to hammer out the roll pin on the back of the trigger guard but have just managed to ding it upÖany suggestions?

faawrenchbndr
05-26-2011, 15:32
Hold on slick! :wow:

Have you gotten the forward side to pivot down?

Be dang *** careful or you will break off the rear tabs from the receiver.
They are easy to remove, use a 1/8" drift, support the receiver and the
tab and drive the pin out.

glock30user
05-26-2011, 17:11
yes i got the forward end out no problem…i didnt support the receiver when i was trying to get the pin out…maybe that was causing the force to be displaced. idk

scottMO
05-27-2011, 19:59
soak it for a few minutes in some sort of gun oil or wd40 as it should loosen up the roll pin...