slide locking issues [Archive] - Glock Talk

PDA

View Full Version : slide locking issues


motorjon68
05-28-2011, 20:40
I'm sure this has been addressed, but the terms are so common that tons of stuff comes up when I search. I apologise. Anyway, the slide on my 26 locks back in place even when there isn't a mag in. I noticed that the slide release is 'up' and not down like it should be. Any ideas? thx, Jon

JR
05-28-2011, 20:46
You installed it incorrectly. Take it back out and reinstall again. Locking block pi first, trigger pin second, make sure the spring is UNDER the locking block pin!