Question about detail stripping Glock 17. [Archive] - Glock Talk


View Full Version : Question about detail stripping Glock 17.

07-17-2011, 09:30
I just finished detail stripping my G17 for the first time and am wondering if this can cause wear and tear on the gun. I noticed that the back pin for the trigger assembly actually pushed out a burr of plastic albeit a small piece. Since all the pins are basically pressure seated I can imagine that each time you remove them you are loosening the pin holes.

Don't plan on detail stripping very often, but would like to know about this anyway.


07-17-2011, 14:37
Your Glock is intended to be used and maintained. Dont worry about the pins working loose. If, by some strange reason it did happen, the frame is lifetime warranted.