timbersmith stocks&nhm90 [Archive] - Glock Talk

PDA

View Full Version : timbersmith stocks&nhm90


buddah
09-28-2011, 07:59
Converting my NHM90 to 922r. Will timbersmith wood stocks fit my nhm? . Don't want to go ironwood designs because timbersmith is already finished.

mrmedina
09-28-2011, 15:03
For technical questions call 800-554-1445 8am-4pm Mon-Fri or

Email us your question at: techquestions@tapco.com :wavey:

CarlosC
09-28-2011, 15:21
And you don't want to try finishing an Ironwood stock? When you get them, they are ready for staining...I mean 100% ready. It's a lot easier than you think, even if you've never finished any wood...
Ironwood before
http://img.photobucket.com/albums/v440/CarlosC/Guns/Rifles/Bulgarian/SSRwoodstock.jpg
Ironwood after
http://img.photobucket.com/albums/v440/CarlosC/Guns/Rifles/Bulgarian/SSRwoodstock-1.jpg
http://img.photobucket.com/albums/v440/CarlosC/Guns/Rifles/Bulgarian/SSRwoodpistolgrip.jpg
http://img.photobucket.com/albums/v440/CarlosC/Guns/Rifles/Bulgarian/SSRwoodhandguards.jpg

buddah
10-02-2011, 11:38
Ironwood=$130 plus shipping+cost of hardware+time and $ to stain wood.
Timbersmith=$125 shipped, includes all hardware, already stained.
From what I am seeing on various internet webpages, I have to do alittle filing on the timbersmith due to the MAK 90 having a 1.5mm receiver. The only PITA part will be the hanguard. Will need to do some sanding on the inside to make it fit. Got my dremel ready.

buddah
10-09-2011, 09:21
FYI- finally did the full 922R compliance thing to my NHM90. The tapco/timbersmith brown laminate wood stock fit perfectly, no mods needed. Just a very slight gap that is hardly noticeable. The only pain in the butt was the lower handguard which required lots of sanding and some trimming. Also cut notch in safety lever to hold bolt open.