S&W M60 fired cases stick

[Cruisin23]

Model 60 , .357 - I've always had issues with this gun dropping fired .38 spl cases out. They always seemed to catch right at the case mouth. Now that I've started reloading for .357 also, I've found that reloaded ammo has a harder time going in and the first batch of (relatively light) .357 I could NOT extract by hand, I had to take a dowel to them to get them out. This is not an issue on my Model 65, even with the same loads. Did S&W make these with tighter tolerances in the chambers?

I've looked at polishing the chambers, but they really don't look very rough. Any other ideas?

Also, anyone have an opinion on the WC spring kits for these from MidwayUSA?

TIA
Cruisin'

[Cruisin23]

chirpchirpchirp..... anyone out there?

[faawrenchbndr]

This is happening with a clean cylinder on the first firing?

[Cruisin23]

This is happening with a clean cylinder on the first firing?

Yes sir. And like I said, this is not an issue with my Model 65.

[mace85]

I know this is an old thread, but see if this works. Check the case mouth of your reloaded ammo, see if you are removing the bell on the case completely. If not maybe take your micrometer to the chamber as see if they are cut to spec. Might have to call S&W to get the dimensions you need. Does this happen with new ammo as well as reloads?