SP101 revolver question [Archive] - Glock Talk


View Full Version : SP101 revolver question

05-08-2012, 18:57
Currently have a Ruger SP101, spurless, 2 1/4 bl revolver. The factory grips did not feel comfortable to me while shooting( kind of hard/hurting in the hand). I was thinking of the Hogue grips, but also considering a set of CT lasergrips. Anyone out there have the setup with the CT's on their SP101...how does it feel in the hand..any problems with a holster designed for one without the CT attached not working with the CT attached..thanks in advance for any help. Mainly concerned about the feel.

05-08-2012, 19:05
Cant comment on the CT grips, but I do have experience with the Hogues and a SP101. If you get the Hogues I prefer the soft rubber vs the hard nylon. I have tried them both.

05-08-2012, 19:38
I've had two SP101s, only have the 3"er right now. My attitude is that if I'm going to carry a .357, I'm going to run hot loads for self defense and I use Buffalo Bore 158 gr JHPs. They run about 1320 fps in my gun.

The factory grips hammer my middle finger (can't do without your middle finger when driving :supergrin:).

I found the rubber Hogues to be vastly more comfortable, middle and all other fingers are fine. Don

05-08-2012, 20:29
The hogue grips feel better than a woman's breast.

05-09-2012, 04:42
When I was looking at SP101's I liked the look of Trausch grips, they're relatively big though:

I also liked the look of Badger grips, they make two-finger and three-finger versions:

Bruce M
05-09-2012, 05:27
The hogue grips feel better than a woman's breast.

Got to be the wrong woman then:supergrin: