My 14 year old son and I took out his SR22p again today after I drifted the front sight a little to the left. We couldn't get it zeroed real well with the adjustable rear sight. We had been shooting alot of steel targets and were both a little off. We had the rear sight way off centered to the right in order to hit targets- we always seemed to miss a little left as evident by the dirt splash in the berm. And when we painted the plates white, we noticed the hits were always left of center. I got to looking at the front sight and it was just a little too far right. I drifted it to the left and centered it on the slide, then centered the rear sight to start over with zero-ing the gun. It was dead on right away with no more adjustment. We shot today at a 25 yard outdoor range, we had steel targets set up at 10, 15, 20, 22.5, and 25 yards, and couldn't miss. There are pine trees overhanging the rear birm, and we were shooting all of the pine cones that had fallen into the range on the birm wall and just in front of it. Man this is a fun little gun. I cannot believe how accurate it is for such a short barrel. We have right around 1500 rounds through it and the slide shows absolutely no wear. The barrel has just a ghost of a smiley from the slide cycling, but I am impressed with the lack of wear. They have fixed any slide stop issues from the early guns. There is even a hardened steel pin set in the slide where the slide stop engages the slide that prevents wear in the aluminum of the slide. The little pin was shiny metal when new, and remains so, with no wear. The slide is still ALL black with no wear from the slide stop lever riding against it as early owners reported. Accurate, shoots Federal cheapo Wal Mart ammo problem free, durable, light- gotta love it. If I'm honest though, the trigger reset is weak, and the trigger takeup is mushy- even though it is not hard to find the trigger break point (I guess that is good enough terminology :homer:). I'd estimate the trigger break is a bit under 4 pounds now that it is good and broken in. It is super easy to field strip and clean all but the frame, until I discovered that compressed air will clean it very well. So that little problem is solved. Anyone thinking about one of these should think no more and purchase one. My son and I really like his.