550 casefeeder part deux

[norton]

Tonight I changed the casefeeder over from .45 Colt to .45 ACP.
The results were positive. If anything the acp case feeds much smoother then the Colt. It made my mirror setup unnecessary.
BTW, no adjustment was necessary, other then changing over the adaptor.
I loaded 100 rounds of my Lyman cast bullet.
So far I have been pleased with the casefeeder. I had 2 or 3 cases not center over the primer feed, but this was easily corrected without damage to the cases.
I will tell you I have been an off press resizing/depriming guy for a while. It keeps the primer feed clean, and I can resize on a single stage while watching TV.

[Colorado4Wheel]

9mm was a pita. IIRC 10mm was better.

[norton]

9mm was a pita. IIRC 10mm was better.

The only conversions I currently have are The .45's. I may purchase a .38/.357 later.
I can see where they would require readjustment. Smaller diameter case.
Most of my other cartridges are loaded in low volume. .40 and .44 mag. I will continue to load them on my R/C.
9mm may be tricky. I just purchased a Beretta 92 and 1000 berry's plated bullets. I have been toying with the idea of maybe buying a Square Deal for 9mm. We will see.