glock parts [Archive] - Glock Talk

PDA

View Full Version : glock parts


rickyp
11-04-2012, 15:44
I am working on converting a glock 19 in to a gock 23
I have a glock 23 barrel and slide, Last night I just changed the ejector.
I am now tinking about doing some more work to it and wondering if the things I am looking at are a waste of money or work?

1) Glockworx Titanium Firing Pin Safety
2) Lone Wolf 3-1/2 lb Connector
3) Glockworx Competition Trigger Spring

I am also thinking maybe a titanium striker

TxGlock9
11-04-2012, 15:48
Not sure if you can do this.. 23 to a 19 is fine but the other way around I don't think so.

rickyp
11-04-2012, 15:57
Txglock9 it is very easy to do. The only diffrance between the 19 and 23 frame is the ejector and i just changed it out. The 19 ejector did work but it was a little close to the primer so for safety sake i changed them out. Only about $8 in parts and 5 minutes of work.

TxGlock9
11-04-2012, 16:02
I was under the impression the breechface and the chamber don't line up, but if it works it works.. :)

As far as if the mods you're curious about, I would go with the trigger spring and ghost 3.5 connector. I can't say anything about the titanium striker bc I never used it before.

rickyp
11-04-2012, 16:05
I put a entire glock 23 factory (for now) slide on the frame so no issues.

Arc Angel
11-04-2012, 16:08
I was under the impression the breechface and the chamber don't line up, but if it works it works .......

That's true for a 9mm conversion barrel when it's installed in a G-23 slide. The difference in where the striker hits the primer ain't much, though.

TxGlock9
11-04-2012, 16:15
I put a entire glock 23 factory (for now) slide on the frame so no issues.

My mistake in comprehending what you originally posted. doh!

DannyR
11-04-2012, 16:57
As long as your G19 has a locking block pin, you are good to go.

Arc Angel
11-04-2012, 17:54
Ain't THAT the truth! (Thanx, Danny. I forgot about that one; but, then again, it's been awhile since that design change.) ;)