View Full Version : guys part of the group buy mold on cast boolets
Where are u going to start your work ups?
I am thinking the 195 gr start at 9.4 800x and work up. Thinking I am going to end up around 10.4 or so.
Anyone else got some test ideas?
Blue dot at about 9.0 grains probably stop at 10.00
Start at 10.5grs AA#9 and go from there.
I'm thinking with the 185gr HP version, AA#9 is going to run out of space (over 100% load density) before reaching maximum pressures, so I'll have to switch to a powder more compact, probably 800x.
Ctious, I'm guessing your right in the zone with your 800x loads, but go slow and careful when you get at, and certainly past, 10.0grs with the 195gr
vBulletin® v3.8.7, Copyright ©2000-2014, vBulletin Solutions, Inc.