deuce32
09-17-2004, 06:58
Anyone here have experience with the "Carver/hunting" aimpoint mount?
first, directions say to take out original trigger pin. i'm ok with that. it's replaced when mount pin is installed.
It also says to remove the pin above the trigger pin. what does this pin have to do with the mount? the directions never say to re-install it. any ideas?
Also, after mount installation, test firing went good except that the last round failed to feed and the slide locked open. never happened before mount was installed. can't see anything that would cause this. any help/advise is appreciated. thanks
first, directions say to take out original trigger pin. i'm ok with that. it's replaced when mount pin is installed.
It also says to remove the pin above the trigger pin. what does this pin have to do with the mount? the directions never say to re-install it. any ideas?
Also, after mount installation, test firing went good except that the last round failed to feed and the slide locked open. never happened before mount was installed. can't see anything that would cause this. any help/advise is appreciated. thanks
