p22 detail strip

[mbsigman]

Anyone out there know of published detail strip instructions for a P22?

Thanks

Mike

[Chopperdog]

Try this link. (http://www.sju.edu/~bc165187/) Click on the picture of the P22 and then on the complete tear down link, and there you have it.

[Rob72]

Not too difficult, but easy to lose small springs. After you drift out the retaining pins, pull the plastic grip frame out over the SN# stamp, and slide the receiver up and out. Be sure to keep 1 finger on the slide release, as you do this. The spring for the release is non-captive, and the S/R is held in place by the grip frame. There are two Phillips head screws holding the slide plates together. I would suggest working the plates apart over a big, white, plastic tub. It gets a bit complicated from there, but its a start;f

[Navy87Guy]

That's a great tutorial...

Does anybody know how close the P22 break down is to a P99?

Thanks!

Jim

[mbsigman]

Mr Chopperdog,

Thanks for the great link! However, question:

How does one remove the pin for the magazine catch (and spring)? Just push it through?

Mike

[mbsigman]

Mr Chopperdog,

Thanks for the great link! However, question:

How does one remove the pin for the magazine catch (and spring)? Just push it through?

Mike

[Chopperdog]

Originally posted by mbsigman
Mr Chopperdog,

Thanks for the great link! However, question:

How does one remove the pin for the magazine catch (and spring)? Just push it through?

Mike

Yes, it just taps out from left to right.