Rubber Finger Grooved Grips For the Vertec Frame

[glockarella]

Can any one tell me where I can purchase Hogue or Hougue "Like" finger grooved wrap around grips for the Beretta 92SF Inox Vertec 9mm?

Crimson Trace are too expensive & I really don't need the laser feature.

tprs@yahoo.com

[Navy87Guy]

You can buy them from Hogue -- but they will charge you about $50 a set.

Or...you can make your own. Following a thread I read on Beretta Net, I bought a set of "standard" 92 wrap-around grips and modified them. I put them on the gun, scribed a line along the back of the grip to mark the end of the frame, then used a large pair of scissors to cut back the extra material. If you want, you can use a Dremel to smooth up the backstrap edge. Otherwise it's a little "unfinished" along the back edge. For $15, it was well worth it.

Pics of my 92G Vertec are posted on my web site, here: http://users.adelphia.net/~navy87guy/beretta92g.html

Jim

[glockarella]

Thanks Jim:

I attempted to do the same with an extra set of grips from a 92FS that I traded in on my new Beretta Inox Vertec 92FS. I'll have to buy a dremel tool to finish them off. I even took it a step further. I placed the Inox Brigidier slide from my other Beretta Brig. Inox 92SF on the frame of my Beretta Inox Vertec Frame. Nice combination. Points well, heavier, on target faster! You diid a good job blending the grips to the frame. I'd like to get a pair of the gray rubber finger grooved grips from Brignoli's in Italy and trim them down to fit my Inox frame. I'm thinking that Hogue makes them for export only for the European market. Does anybody know?

Tony tprs@yahoo.com