View Full Version : My G20 chamber support questions
MXRacer101
07-25-2005, 20:18
I have just purchased a G20(NIB 3rd gen) and it’s still unfired . I recently checked my factory rounds(Hornady and CCI Blazers) for chamber support. The case is not fully supported over the feed ramp (I knew this one was coming, but not the next one). The rounds are loose enough to rattle freely in the chamber. The Chamber is not tight at all.
Are your stock G20 or G29 the same? My G32 isn't.
Freeze N
07-25-2005, 20:30
Mine is the same way. No problem unless you are going to try and reload hot rounds, then you get the buldge in the 6:00 spot. Carry hot rounds, and load down for practice and no problems. If you don't reload, don't worry about it.
ColoradoGlocker
07-25-2005, 21:05
.
MXRacer101
07-26-2005, 08:16
Thanks for the replies.
If figured as much on the reliability part. The only thing that stood out is how loose it actually is. I have a safe full of fine military/LE weapons, this one seems excessive. I will be chambering the hot stuff (Reed’s Ammo) and making my own custom reloads, so I guess a new barrel is in my immediate future. It looks like Bar-Sto has the factory length barrels in stock, guess I’ll get one of those.
Thanks again
vBulletin® v3.7.3, Copyright ©2000-2009, Jelsoft Enterprises Ltd.