Maximaking
11-21-2005, 20:59
Ok Guys, I just picked up a P32 and it was really dirty. I detail striped it and now it has a funky trigger reset. I think I may have messed up on how the hammer block spring is installed. Here's what's happening.
1: Dry-fire the pistol, triger pull is normal DA.
2: While holding triger in rack the slide. The hammer resets to normal position.
3: Release the triger maybee 10% of the way back to the front and you hear a click
4: Pull the triger and the hammer falls from what I would call the "rest" position.
I doubt this is normal, is this due to the block spring?
Todd
1: Dry-fire the pistol, triger pull is normal DA.
2: While holding triger in rack the slide. The hammer resets to normal position.
3: Release the triger maybee 10% of the way back to the front and you hear a click
4: Pull the triger and the hammer falls from what I would call the "rest" position.
I doubt this is normal, is this due to the block spring?
Todd
