Glock Talk

Glock Talk (http://glocktalk.com/forums/index.php)
-   The 10 Ring (http://glocktalk.com/forums/forumdisplay.php?f=38)
-   -   One Source Tactical (http://glocktalk.com/forums/showthread.php?t=1455693)

adamsoa 12-01-2012 20:21

One Source Tactical
 
I have gen 4 that I want to have milled to take a deltapoint. Will milling the frame for the sight make it weaker?

Sent from my SCH-R760 using Tapatalk 2

Happypuppy 12-01-2012 21:36

I had a gen 3 19 milled and it was very strong. Not that much material is taken and the dovetail piece pretty much replaces some of the integrity.


Sent from my iPad using Tapatalk HD

Opie 1 Kenopie 12-02-2012 03:14

I hope you mean milling the SLIDE Adam.

And Happy, I've never known a rds to REPLACE the integrity of a milled slide. The material is gone, plugging the hole with an optic doesn't make it as strong as it once was. That being said, milling a slide doesn't significantly weaken a Glock slide.

Ethereal Killer 12-04-2012 23:37

it doesnt effect significant areas unless you do a iron sight to the rear configuration.

with the irons left in their slot and the RDS to the front, the mill slot comes VERY close to the extractor pin channel. this can be solved by shoving the RDS all the way back and milling a new more shallow slot for the iron.

AS a matter of personal preference I feel that the primary sight system should be the one up in your face when shooting thus I feel that the BUIS should fall in front of the RDS just behind the chamber.

AS far a deltapoint, I would stay away from OST and go with Bowie Tactical. they are the experts on the deltapoint and have installed many thousands more than OST.


All times are GMT -6. The time now is 18:22.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2013, Glock Talk, All Rights Reserved.