View Single Post
Old 08-04-2009, 19:06   #20
Jumper
Senior Member
 
Jumper's Avatar
 
Join Date: Jun 2002
Location: MI USA
Posts: 2,186
Quote:
Originally Posted by Colorado4Wheel View Post
Not if he has a older barrel that guppies his brass badly. Then I wouldn't want to load the brass no matter what dies you use. In fact no dieset is any safer then the other. That doesn't make any sense to me at least. They all resize the brass and if they pass the chamber check will shoot about the same.
If its guppied too bad to resize then it can never be reloaded. If its capable of being resized without wrinkling or gross distortion then why isn't it safe to reload? I assumed the OP possessed ordinary common sense and I didn't feel it was necessary to state the obvious.

If after resizing the brass springs back too much to hold a bullet, then it is work hardened and should be discarded. But this goes beyond the OP's original question.
__________________
10 Ring Member #661944

You can have my guns when I run out of ammo. Which wont be happening anytime soon.
Jumper is offline   Reply With Quote