View Single Post
Old 01-16-2010, 11:05   #8
fredj338
Senior Member
 
fredj338's Avatar
 
Join Date: Dec 2004
Location: so.cal.
Posts: 21,651
Blog Entries: 3
Yep, efficient loading on a ss press requires better technique. Son't prime on the press, painfully slow. Use a hand priming tool. Do all the steps one at a time; size, then bell, then prime, then seat & crimp. If you use a powder measure, you can load 60-70rds of handgun per hour, but that is hauling butt. I still load my high powewr rifle stuff on a single stage even though I run two 550B for handgun ammo. I even have dies for some of my handgun stuff & load test batches on the ss press. It's just easier than setting up the 550B for 20rds.
__________________
"Given adequate penetration, a larger diameter bullet will have an edge in wounding effectiveness. It will damage a blood vessel the smaller projectile barely misses. The larger permanent cavity may lead to faster blood loss. Although such an edge clearly exists, its significance cannot be quantified".
fredj338 is offline   Reply With Quote