Originally Posted by Boxerglocker
Why pull them? What is wrong with just reseating them to your desired length and recrimp? BTW, I have a buddy that loads that 124fmj and 231 to 1.130 OAL and that load is pretty damm good.
This is all new to me, so can I just readjust the seating die to the proper length and run the rounds through again?
I did notice that there is a little bulge in the casing where you can see the actual bullet but I checked the rounds w/ a Wilson Max-Cartridge gauge and they all fit fine.
Edit - I can post pics if need be but it may be hard to see w/ a camera