View Single Post
Old 01-26-2010, 12:26   #22
unclebob
Senior Member
 
unclebob's Avatar
 
Join Date: Oct 2000
Location: Mary Esther FL
Posts: 6,878
Quote:
Originally Posted by kcbrown View Post
The Lee sizing die isn't long enough to allow normal installation in a 650. I haven't tried installing it with the retainer on the bottom instead of the top, but based on how far the threads are from the tip of the die, I'd say that approach probably wouldn't work either. This is with new Lee carbide dies.
It works for me. On the 650 you can put the lock ring on the bottom of the tool head or you can use the Lee lock ring turn it over and use the top side of the lock ring without the rubber ring. Or replace the Lee lock ring with the Dillon lock rings. You only need about or more of one thread showing above the tool head for it too work.
__________________
Team Carver Custom
NRA Certified Instructor
NRA Benefactor Life Member
GSSF Life Member
___________________________________________
unclebob is offline   Reply With Quote