View Single Post
Old 03-18-2010, 21:29   #3
jesse_james
Registered User
 
jesse_james's Avatar
 
Join Date: Feb 2010
Posts: 18
thanks kegs. that looks like what ill have to do i better order my brass now so at least i have it when my barrel gets here lol. there is one way to take care of the problem. THAT IS ON GRAF AND SONS WEBSITE THEY HAVE A COMPLETE PUSH THROUGH SIZING DIE.. HERE IS INFO ON IT.
Product Information


The Redding G-Rx Carbide Base Sizing Die meets the need of the reloader needing to reload brass shot through some of the most popular autoloaders today. These autoloaders, when fired, produce a bulge at the bottom of the brass, which normal sizing dies can not reach and remove, rendering the brass unusable. Simply push the brass through the sizing die and the bulge in the web of the brass is removed. This step fully sizes the brass back within the accepted SAAMI specification for brass diameter. After the brass has been pushed through the die it may be resized in a standard sizing die allowing once unusable brass to be reloaded normally.

The G-Rx Carbide die set comes packaged with a pusher rod which fits into the ram like a shell holder and the unique push through sizing die with lock ring.

To use simply place the brass on top of the pusher rod. Then raise the ram to push the brass entirely through the die. The resized brass is then held in a rebated portion of the die for easy removal.

IT SOUNDS LIKE IT WOULD WORK BUT I THINK ILL JUST ORDER THE NEW BRASS CAUSE I ONLY HAVE ABOUT 500 RDS OF BRASS THAT I RECYCLE WITH STOCK BBL. THE REST I WAS SAVING UNTIL I FOUND A SOLUTION TO OUR PROBLEM. IT SOUND LIKE BOTH WILL WORK BUT I DONT WANT TO INSTAL THAT DIE IN MY PROGRESSIVE. I GUESS IF YOU HAVE A SPARE SINGLE STAGE PRESS THIS WOULD BE THE PERFECT ADDITION TO HAVE THIS DIE SET UP IN AND THEN BE READY TO GO THREST OF THE WAY IN THE DILLON... DILLON PRESSES ARE AWSOME BY THE WAY!
jesse_james is offline   Reply With Quote