View Single Post
Old 03-26-2010, 17:15   #6
MinervaDoe
Senior Member
 
MinervaDoe's Avatar
 
Join Date: Jan 2009
Location: Way out in left field
Posts: 7,020
Blog Entries: 5
I like the 1911 (I own two), but I hate it when hardcore devotees of any brand / style of guns look down their noses at other styles of guns. It's a luddite mentality.

If the you want to use the 800-X and you find that the RCBS uniflow powder measurer is giving too much variance, you might figure what the center of the safe range for 800-X is and see if the variance does not throw you outside of the safe range.

I've had a few powders which did not meter well, but I've rarely had the variance be so great that I couldn't keep the load within a safe range by doing what I describe. If your variance is higher than that, throw your loads on the low side, measure each one and add powder until you hit your mark. Difficult but do-able.
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.

Last edited by MinervaDoe; 03-26-2010 at 17:16..
MinervaDoe is offline   Reply With Quote