View Single Post
Old 03-28-2010, 00:32   #5
cwshootersupply
Senior Member
 
Join Date: Sep 2006
Location: Louisville, KY
Posts: 268
Quote:
Originally Posted by ejohnson View Post
Hello,
I have finally managed to get into a couple of the NRA gunsmith classes at Montgomery College. Many thanks need to go to my family for supporting this. Anyway, the budget is still a concern so I thought I would ask folks on a couple of different forums for opinions.

In my experience, tools fall into one of three categories:
One: Complete junk. With lots of cursing and a little luck, you might get through one job…
Two: Meh. Will hold up for a couple of jobs, but may still involve cursing. Great for beating on, using torque multipliers, cutting into custom shapes, etc…
Three: Good stuff. These get the job done every time.
Four: Masterworks. These are a pleasure to work with, but at the cost of a second mortgage.

So, with that in mind I am looking for the following stuff in the second or preferably third group and ideas on good places to buy them.



Drill Bit set: I need a complete 115 piece “three way” set. I am clueless on this one; I usually just sharpen up sometime from the box… so it is obviously something I really need!

Buy from Grainger and Auto Zone and Sears for brill bits. Use a Drill Doctor to sharpen. Also can sharpen a bit by hand. That was the secert of having a tool and die background. Did a lot of hole drillen and learne to sharp by eye . as well a tool and cuter , and the DD.

Dial Caliper and micrometer: OK, I have never owned either one, so I am clueless on these as well. I suspect the ones at Harbor Freight are not up to the job, but a top of the line is not in the budget.

Screw driver set: I am leaning toward a Chapman set (8900 Gunsmithing) to get me started. I know a bit type set will have some “reach” problems, but I figure I can back fill with Grace style drivers as I need them. What do you guys think?
CEW-Chappman I an't to impressed. I would use Brownells insteaad.
Me and the wife went to PIgon Forge TN and I bought a bucket load of screwdrivers and other stuff from some store called the Tool Source or something ....Stuff I can grind into special tips or make tools from.



Punch Set, with Cup tips: The required tool list includes these from Brownells (080-000-645). They seem like a necessary tool for certain firearms, but they are pricy for a full set and I don’t know how often I would use them. Can anybody tell me which firearms need these? Are there any other (cheaper) place to buy them from?

Files: What do folks think is a good cut to go with that is between a bastard and a stone? I can’t find anything other then bastard files locally to “finger” test. Is “smooth” to fine? CEW- No a smoothe is not to fine

Norten stones: Where to get… CEW- Brownells ,MSC, Midwayusa

Lath and Mill bits: Where to get…CEW- Best to find local retail machine shop supplier else see above ^^^^

Thanks,
Eric
Replied to questions in your quote.
CEW
__________________
Sales and Service 1-866-217-5990
502-231-1118

To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.
cwshootersupply is offline   Reply With Quote