View Single Post
Old 04-06-2010, 12:57   #1
rsm688
Senior Member
 
rsm688's Avatar
 
Join Date: Jan 2007
Posts: 345
How to port slide/barrel?

Okay I have a VERY good machinist friend and I want to port the slide and barrel on my walther p99c in .40. What all do I need to tell him to do? I figured get it set up like I want and have him drill through the slide, insert and mark the barrel, and have him drill through the top of the barrel. Use an end mill and smooth it out and then check the barrel and have it refinished. Is there any particular angle that helps with the porting versus just a straight 9o* angle? I am not a machinist so I am just trying to figure out what to tell him to do .




Thanks,
Spencer
rsm688 is offline   Reply With Quote