Thread: CQC-7 Questions
View Single Post
Old 05-13-2010, 22:12   #1
BRabbit
Senior Member
 
BRabbit's Avatar
 
Join Date: Feb 1999
Posts: 957
CQC-7 Questions

I have a mid-90s CQC-7 collaboration between Mr. Emerson and Benchmade (good knife, no problems, I'm very impressed with it - details as I recall from the 1990s regarding the knife were 154CM steel IIRC, tanto, non-combo blade, chisel ground on one side, 50,000lbs tensile tested blade, zytel handles, hex-screws with allen wrench needed on blade and clip to adjust, titanium liner lock, etc) and am thinking of purchasing a newer Emerson version the the knife (EMERSON CQC-7 TANTO 3.3" B-T COMBO).

My questions are as follows:
(1) What changes have been made to the new knife from the one I now own?
(2) What was the reason for these changes (i.e.: What improvements were gained by the changes)?

Thank you.

Last edited by BRabbit; 07-18-2010 at 21:34.. Reason: Rereading it, I was less patient waiting for an answer than I should have been in my original posted question. My apologies.
BRabbit is offline   Reply With Quote