View Single Post
Old 08-11-2010, 02:44   #23
HiredGun77
Senior Member
 
HiredGun77's Avatar
 
Join Date: Oct 2004
Location: North Bend Oregon
Posts: 560
I use the RCBS carbide dies with the Lee factory crimp die. If I were buying it again I would have just got the Lee dies. Using the factory barrel I had a lot of brass split lengthwise where once I switched to the LWD barrel that issue is gone. It is much better supported so no more bulges. I lose my brass long before they ever wear out. I have tested my load in 10 test brass to 30 reloads and they are still fine. No noticable stretch with my current setup. I get the same results in my 40 loads. You will find Longshot powder to give maximum performance with minimal pressure. CCI-350 primers work well too with this powder.
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.

Custom Rifles - NIC Certified Cerakote Applicator
HiredGun77 is offline   Reply With Quote