View Single Post
Old 03-27-2011, 08:18   #13
bmwmpb
Registered User
 
bmwmpb's Avatar
 
Join Date: Dec 2008
Location: Greenville, S.C.
Posts: 1
Great thread. Thanks for all of info. I would feel pretty comfortable purchasing a used gun. Utilizing all of the posts, here's the current check sheet:


1. Visual inspection of exterior for damage, scars, wear.
2. Look for hogged out pin holes in the frame. Press them out and put them back to make sure everything is correct.
3. Check the breach face. If it has a inward dimple around the firing pin hole, this will indicate the pistol has been shot alot, maybe with hot hand loads.
4. Check recoil spring by aiming gun verticle (unloaded), no magazine, pull slide back and slowly let forward to see how slide goes into full battery.
5. Load mags for function.
6. Cycle loaded mag through gun by racking slide.
7. Dry fire for function. With the trigger held back, push on the top of the chamber. If there is a lot of movement, it's pretty worn. If there is just a little, less so, but keep in mind, even the new guns will have a little play when you do this.
8. Field strip
9. Inspect internals for cleanliness, wear.
10. Check for aftermarket internals.
11. Run your pinched fingers down the barrel feeling for bulges.
12. Look for any rings or pitting IN the barrel.
13. Make sure the extractor is not broken
14.Check documentation of test fire date, S/N, matching numbers

Last edited by bmwmpb; 03-27-2011 at 08:19..
bmwmpb is offline   Reply With Quote