View Single Post
Old 03-02-2012, 15:56   #156
ken grant
Senior Member
 
Join Date: Apr 2004
Location: middle ga.
Posts: 1,331
#1---- The spring loaded bearing head is thicker on the ones for the non-LCI,s
Two different bearings for LCI's & non-LCI's

#2--- It was just an idea on my part. Have not tried it yet.
I did take a look at it and decided that the bearing for the LCI ext. would not push into the recess to let a thicker head fit.
I believe the bearing bottoms out on the plunger.

I will try a non-LCI bearing( thickerhead) that I have on hand to see if it will increase spring pressure on the extractor. I am sure it will bottom out so I will cut just a little off the tail.
ken grant is offline