View Single Post
Old 04-28-2012, 20:03   #199
Colorado4Wheel
Senior Member
 
Colorado4Wheel's Avatar
 
Join Date: Nov 2006
Location: CO
Posts: 14,388
Use your dial calipers thin end to measure a little below the flare and then the thick end to measure the very end at the flare. Confirm it's all gone but not going inward. Then seat the bullet deeper till it goes thunk. Let us know how short that is. I think the shoulder of the bullet is too far out of the case. But I am using my smart phone.
__________________
Steve

Last edited by Colorado4Wheel; 04-28-2012 at 20:07..
Colorado4Wheel is offline