Thread: Crimping ?
View Single Post
Old 09-13-2012, 18:23   #8
fredj338
Senior Member
 
fredj338's Avatar
 
Join Date: Dec 2004
Location: so.cal.
Posts: 21,794
Blog Entries: 3
Quote:
Originally Posted by Colorado4Wheel View Post
Taper crimping IS deflaring. Simple as that. Only time your are actually bending the case inward is when you have the bullet seated short enough to bend it inward with out denting the bullet. Its pretty clear if you look at the Lyman reloading manual.
Yes Steve, but it's not called a taper flare but a taper crimp. Come on guys, you are getting way off into the weeds.
__________________
"Given adequate penetration, a larger diameter bullet will have an edge in wounding effectiveness. It will damage a blood vessel the smaller projectile barely misses. The larger permanent cavity may lead to faster blood loss. Although such an edge clearly exists, its significance cannot be quantified".
fredj338 is offline   Reply With Quote