Thread: Crimping ?
View Single Post
Old 09-14-2012, 18:09   #17
fredj338
Senior Member
 
fredj338's Avatar
 
Join Date: Dec 2004
Location: so.cal.
Posts: 21,638
Blog Entries: 3
Quote:
Originally Posted by Colorado4Wheel View Post
A roll crimp die would remove the flare just as well. Just saying. It's irrelevant if all you do is use minimal flare and the declare.
Correct & I have done that. Still, it is correct to call it crimping because you are using a taper crimp die. Semantics maybe, but is what it is. FWIW, I don'tthink I have ecer measured case mouth crimp. If you can see a crimp w/ a taper crimp, it's too much.
__________________
"Given adequate penetration, a larger diameter bullet will have an edge in wounding effectiveness. It will damage a blood vessel the smaller projectile barely misses. The larger permanent cavity may lead to faster blood loss. Although such an edge clearly exists, its significance cannot be quantified".

Last edited by fredj338; 09-14-2012 at 18:11..
fredj338 is offline   Reply With Quote