Thread: Crimping ?
View Single Post
Old 09-18-2012, 03:07   #23
Jager247
Registered User
 
Join Date: Sep 2012
Posts: 15
You will need to remove the bell that the powder/expander die put in. You will either need to use the crimp function of the seater die or FCD to do that. I like to use the FCD because I like to use the post sizing ring as a case gage. If the round doesn't get post sized it should be within spec and function in your gun. If it does get post sized then I set it to the side and inspect it or pull it apart and reuse the components.
Jager247 is offline   Reply With Quote