The front will not come off is installed correctly. You cut off the front bead and then place the sight over the pedestal base. Trace it with a pencil. take it off and with a small file or tip of a small flat head screw driver scrape off the finish from inside the pencil lines. You then take sand paper and remove the finish from the base of the sight, or scrape it off. degrease the areas and follow instructions for install the sight. You are now bonding bare metal to metal and not finish to finish and it will not come off.
J.D. McGuire, Owner
AI&P Tactical, LLC
Remington Factory Certified
Law Enforcement Armorer
Last edited by aippi; 09-18-2012 at 13:19..