Thread: Crimping ?
View Single Post
Old 09-30-2012, 13:06   #77
fredj338
Senior Member
 
fredj338's Avatar
 
Join Date: Dec 2004
Location: so.cal.
Posts: 22,226
Blog Entries: 3
Quote:
Originally Posted by Gpruitt54 View Post
I think you are saying that I should always for the max OAL? Is that basically it?
YEs, the OAL in most manuals is a tested OAL or minimum. Going below that will increase pressures, loaded longer reduces pressures. So think of a longer OAL as insurance. My point about measuring a factory round is it's a dangerous assumption that it is correct or safe. Load a faster powder, like AA#2 to the top end & then load it at shorter OAL, you are pushing over pressure. Since most powders do NOT build pressure in a linear fashion, there is really no "a little over max". Some powders spike as you go over the top end, some spike badly enough to cause a KB (Clays, TG), so just plugging in a factory OAL can get you into trouble with wrong loads.
__________________
"Given adequate penetration, a larger diameter bullet will have an edge in wounding effectiveness. It will damage a blood vessel the smaller projectile barely misses. The larger permanent cavity may lead to faster blood loss. Although such an edge clearly exists, its significance cannot be quantified".

Last edited by fredj338; 09-30-2012 at 13:08..
fredj338 is offline   Reply With Quote