Thread: Crimping ?
View Single Post
Old 10-02-2012, 13:29   #82
fredj338
Senior Member
 
fredj338's Avatar
 
Join Date: Dec 2004
Location: so.cal.
Posts: 21,146
Blog Entries: 3
Quote:
Originally Posted by PrecisionRifleman View Post
I'm talking about set back that van occur when rechambering a carry load multiple times. Crimping helps prevent this although I personally haven't had a problem with that myself. I just rotate the round from the chamber for one that was in the magazine.

Outdoor Hub mobile, the outdoor information engine
It actually does not. You can NOT taper crimp tight enough to prevent bullet setback. In fact, too ,uch taper crimp can actually reduce neck tenstion & proper neck tension is what prevents setback.
__________________
"Given adequate penetration, a larger diameter bullet will have an edge in wounding effectiveness. It will damage a blood vessel the smaller projectile barely misses. The larger permanent cavity may lead to faster blood loss. Although such an edge clearly exists, its significance cannot be quantified".
fredj338 is offline   Reply With Quote