View Single Post
Old 10-10-2012, 13:55   #18
Fire_Medic
CLM Number 261
Polymer Butcher
 
Fire_Medic's Avatar
 
Join Date: May 2008
Location: The Gunshine State
Posts: 8,145
Quote:
Originally Posted by molar View Post
My 19 had problems from the start, but I too, find it interesting that some guns don't develop the problem until a few thousand rounds are through the gun. One thing I found odd was that the spring loaded bearing and spring was a few mm shorter in my 19 than the one found in my 17. The odd part is that my 19 only had 500 rounds through it while the 17 has several thousand. I wonder if some of the EDP springs are defective and compress under load earlier. I know this would cause a loss of extractor tension, but what effect would it have on ejection and extraction?
I'm sure it would have a negative effect, especially since Apex saw it fit to provide a new spring with their extractors, and I know they did a lot of testing before hand.
__________________
Florida Glockers Club #2250, BHP Club #2250, Niners Club #2250, G1 Niners Club #2250, Black Rifle Club #2250, S&W Club #2250, 40SW Club #2250


ΜΟΛΩΝ ΛΑΒE

RIP GioaJack!
Fire_Medic is offline   Reply With Quote