View Single Post
Old 10-19-2012, 06:49   #128
Fire_Medic
CLM Number 261
Polymer Butcher
 
Fire_Medic's Avatar
 
Join Date: May 2008
Location: The Gunshine State
Posts: 8,129
Quote:
Originally Posted by 9mmdude View Post
I had a 336 and they installed a 30274. They did not change out the extractor and I still have the DIP.

For the life of me I can't figure out why it would run fine for 500 rounds after the ejector switch and then start acting up again.

I didn't get any stove pipes today but the last box of Blazer Brass had almost every single casing peen me in the head out of 50 rounds. I was literally ducking after about 10 rounds, a couple hit me in the shooting glasses.

The gun was very hot and I am wondering if heat adds to the problem.
Try the non dip extractor, Glockparts.com has it. It did the trick for my gun so far.....
__________________
Florida Glockers Club #2250, BHP Club #2250, Niners Club #2250, G1 Niners Club #2250, Black Rifle Club #2250, S&W Club #2250, 40SW Club #2250


To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.

ΜΟΛΩΝ ΛΑΒE

RIP GioaJack!
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.
Fire_Medic is offline   Reply With Quote