View Single Post
Old 11-20-2012, 06:03   #30
Senior Member
Veedubklown's Avatar
Join Date: Sep 2010
Location: Northwest AZ
Posts: 2,083
I have an FM Hi-Power (from Argentina), mine came with the magazine disconnect already removed. I installed a set of hogue wrap-around grips, to replace the stock ones. They felt like you were holding a beer can, and beat to hell.

The Browning Hi Power Club

After building my 1911, I was fairly confident I could stone a BHP hammer/sear, and I was pretty successful. My trigger is at about 4lbs, which is perfect for this gun. I carry it in the winter, and shoot IDPA with it. I then put a small weld bead on the front of the trigger, where it contacts the inside of the frame. Then, filed and fitted it, to act as an over-travel stop.

The Browning Hi Power Club

Bought new trigger bar from browning, because it would be slightly longer than the one already in it. I fit it, to reduce the reset. Now, this trigger is about as close as you can get to a 1911. This FM already came with night sights, so until I decide when/how I want to refinish it, this is how it is.

It also already came with a pachmayr extended slide lock, and ambidextrous safety.
I don't always rock out with my glock out, but when I do, it's all the way.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 signatures.

Last edited by Veedubklown; 11-20-2012 at 06:06..
Veedubklown is offline   Reply With Quote