View Single Post
Old 12-08-2012, 20:17   #4
cciman
Senior Member
 
cciman's Avatar
 
Join Date: Jan 2009
Location: SW Ohio
Posts: 2,512
Detail strip and clean out the the firing pin channel, and the clean the striker safety, extractor components.

Check the contents of the striker pin channel while doing so: you might as well take out and check the sleeve when doing so to make sure it is not falling apart or broken (search the forums on how to do this-- i think I posted some tips for removing without damage), look at the tip of the striker.

You might want to replace the striker spring with a Wolf Xtra power striker spring to improve reliability.

Yes the trigger bar should be contacting (riding over) the safety plunger.
cciman is offline   Reply With Quote