View Single Post
Old 12-25-2012, 19:51   #51
Taterhead
Counting Beans
 
Join Date: Dec 2008
Location: Boise, Idaho
Posts: 2,941
Quote:
Originally Posted by storm2844 View Post
Hi i have a question i have a new gen3 g20 (completely stock) i went to the range the other day with some reloads
180g xtp's
9.2g longshot
Win brass
Wlp primers
They were moving at 1340fps through my crony 9.4g longshot gave about the same. 9.2 had no over pressure signs at all 9.4 had some scratches on the case and burr on the head were the extractor goes.
Does this velocity sound right to you guys? Overpressure?
I checked my chony with a known load and all was good.
Thanks
That load runs quite a bit slower in my G20 (1180 fps), but it is otherwise a decent load with no indications of excessive pressure.

I wonder if you mean where the ejector goes? Scratches, nicks and dings are normal. A warm load smacks into the ejector pretty hard. The case then can bang the corner of the slide on its way out. A photo or two, or at least a bit better desription of the burrs and scratches can let us know for sure.
Taterhead is offline   Reply With Quote