View Single Post
Old 01-13-2013, 14:15   #24
WiskyT's Avatar
Join Date: Jun 2002
Location: North Carolina
Posts: 11,766
Originally Posted by Colorado4Wheel View Post

This is the most important part on the Case Feeder slider setup. You can see it captures the rim of the case, it also has a channel for the primer to move in if there is any primer flow around the firing pin. This is common on brass fired out of a Glock. With out it your just trying to push a case that doesn't sit flat on the subplate into the shell holder. Sometimes it will work, occasionally you will have issues. Hornady simply does not have this part. And on top of it all your moving the case over the spring which is not flat and aggravates the issue.
It's funny because the Pro1000 has no controlled feed. The cases flop down on a flat slide and are pushed into the shellplate by a concave slider. There's no relief for fired primers either. It works great.
Drugs are bad because if you do drugs you're a hippie and hippies suck.
Eric Cartman

"If you kill enough of them, they stop fighting."-General Curtis E. LeMay
WiskyT is offline   Reply With Quote