View Single Post
Old 01-16-2013, 22:24   #7
MinervaDoe
Senior Member
 
MinervaDoe's Avatar
 
Join Date: Jan 2009
Location: Way out in left field
Posts: 7,445
Blog Entries: 5
Quote:
Originally Posted by Taterhead View Post
I picked up a Hornady #9 recently. Earlier editions published data for 10mm Auto for 155 grain an Accurate no. 7. The older max was 15.1 grains. I was always suspicious of that load in light of maxes listed by Accurate and Speer.

The current data is only 12.7 grains. The old data is 16% higher than current print. This is additional evidence to never rely on any single data point for loads.

On a side note, I picked up the most recent Loadbooks. There are a lot of changes there too. The Hornady data above has not yet been corrected.

Noteably, the infamous IMR 800-X with 135 Nosler load is gone.
I'll occassionally pull a load out of an Hornady manual whcih won't even cycle the slide on any of my automatics. To say that they are usually conservative, is an understatement.
MinervaDoe is offline   Reply With Quote